DK series

This polyamide/polypropylene level switch, supplied with nut, is fixed from the inside of the tank. With a small footprint, only 47 mm long, it is perfectly suited for applications in water up to 80°C.
The position of the float on the body allows the contact to be reversed (to be determined when ordering).
It can be reversed for installation at the bottom of the tank. The mounting orientation then determines the detection (high or low level).

SPECIFICATIONS

General featuresDKFBTF4600DKRBTF4620
Body materialPolyamidePolyamide
Float materialPolypropylenePolypropylene
Nut materialNylonNylon
Cable materialPVCPVC
Cable cross section0.34 mm² - 570 mm0.34 mm² - 570 mm
Operating temperature (in
water)
0 to 80°C0 to 80°C
Contact closedNut sideStop side
ApplicationsMulti-purposeMulti-purpose
Electrical features of the contact
Electrical power max.10 W
Electrical voltage (AC) max.140 V
Electrical voltage (DC) max.200 V
Current max.0.5 A
Installation instructions
Mounting from inside the tank
Drilling diameter: Ø8.5 mm
Wall thickness: to 4 mm
Fastening: Seal and nut M8
Tightening torque: 0.6 Nm

A tailor-made request?

Our design office and our sales department are able to offer you an optimal
solution in answer to your specifications:
material, wire, cable, connector, specific accessory…
Contact us to discuss your project together.

Other sensors