DG series

This polypropylene level switch supplied with nut and sealing washer is fixed from the inside of the tank. With a small footprint, only 53 mm long, it is perfectly suited for applications in water up to 80°C.
The position of the float on the body allows the direction of the contact to be reversed (to be determined when ordering).
It can be reversed for installation at the bottom of the tank. The mounting orientation then determines the detection (high or low level).


General featuresDGRHTF2410DGFHTF2540
Body materialPolypropylenePolypropylene
Float materialPolypropylenePolypropylene
Seal materialSiliconeSilicone
Nut materialNylonNylon
Cable materialPVCPVC
Cable cross section0.34 mm² - 500 mm0.34 mm² - 500 mm
Operating temperature (in
0 to 80°C0 to 80°C
Contact closedStop sideNut side
Electrical features of the contact
Electrical power max.30 W
Electrical voltage (AC) max.250 V
Electrical voltage (DC) max.200 V
Current max.1 A
Installation instructions
Mounting from inside the tank
Drilling diameter: Ø8.5 mm
Wall thickness: to 4 mm
Fastening: Seal and nut M8
Tightening torque: 0.6 Nm

A tailor-made request?

Our design office and our sales department are able to offer you an optimal solution in answer to your specifications:
material, wire, cable, connector, specific accessory…
Contact us to discuss your project together.


Other sensors